Many users have reported to experience an error known as '' Hardware Malfunction | The System has halted '' when they try to boot the machine. Under normal circumstances, this error occurs if the hardware component is damaged.
This error usually appears unexpectedly right when you are using the system. However the problem comes with with several troubleshooting steps that can be used to fix this error.
In this article, I will be discussing about Fixing The System has Halted | Hardware Malfunction. You can try the solutions given below to eliminate this error.
Let's get started,
1. Check RAM
You need to also make sure that all of the RAM modules installed on your computer is under good condition. Hence, a simple RAM replacement can solve the issue. To identify the faulty RAM, you need to perform a memory test utility. Once you identify the malfunctioning RAM, replace it as soon as possible.
2. Remove Adapter
One of the network adapters installed on your computer can be the source of the problem. Therefore, it is better to remove any unnecessary network adapters. It is recommended to remove them one by one and restart after each. If the error does not appear after you remove the network adapter, then replace the faulty adapter with a new one.
3. Update BIOS
Another important step to solve the system has halted error is to make sure that the computer is with default BIOS configurations. Restarting BIOS back to its default settings resets BIOS to the way where it was without faults. This process can vary according to the motherboard design and type of hardware.
4. Restart in Safe mode
Sometimes restarting the computer in safe mode alone is able to solve the system has halted error. Booting in safe mode ensures that only limited sets of programs and basic drivers are loaded when you start the computer. Start up programs are not allowed to run in safe mode.
No comments:
Post a Comment